Oreck Vacuum Cleaner MODEL AV 701B User Manual

®
S I M P L Y  
A M A Z I N G  
USERS GUIDE  
2 MOTOR SYSTEM  
•IMPORTANT•  
SAVE THIS BOOKLET!  
MODEL AV-701B  
Includes:  
Important Safety Instructions  
Warranty  
REGISTER YOUR PRODUCT  
ON THE WEB:  
WWW.ORECK.COM  
Operating Instructions  
 
IMPORTANT BATTERY  
HANDLING INSTRUCTIONS  
When using an electrical appliance containing a lead-acid battery,  
basic precautions should always be followed, including the following:  
READ ALL INSTRUCTIONS BEFORE CHARGING THE BATTERY  
WARNING  
To reduce the risk of fire,  
electric shock, or injury:  
Battery Charging  
• Charge batteries for 10 -12 hours before inital use.  
• Never modify the electrical system. Alterations could cause a fire resulting in  
serious injury and could also ruin the electrical system.  
• Use of the wrong type battery or charger could cause a fire or explosion  
resulting in serious injury.  
• The battery must be handled by adults only. The battery is heavy and contains  
sulfuric acid (electrolyte). Dropping the battery could result in serious injury.  
• Never allow children to charge the battery. Battery charging must be done by  
adults only. A child could be injured by the electricity involved in charging the battery.  
• Never lift or carry the battery by the wires or connector. This can damage the  
battery and possibly cause a fire resulting in serious injury. Lift and carry the  
battery by the case only.  
• Read the safety instructions on the battery.  
• Examine the battery, charger and their connectors for excessive wear or  
damage each time you charge the battery. If damage or excessive wear is  
detected, do not use the charger or the battery until you have replaced the  
worn or damaged part.  
Care  
• If a battery leak develops, avoid contact with the leaking acid and place the  
damaged battery in a plastic bag. Please refer to the information on this page  
for proper disposal.  
• If acid comes in contact with skin or eye, flush with cool water for at least  
15 minutes and call a physician.  
• If acid is internally ingested, give water, milk of magnesia or egg whites  
immediately. Never give emetics or induce vomiting. Call a physician.  
• Do not allow the battery to run down completely before charging.  
• Charge the battery at least once per month, even if the vacuum has not been used.  
• Leaving the battery in a discharged condition will ruin it.  
• Do not store the battery in temperatures above 75°F or below -10° F.  
Disposal  
• The battery is a sealed lead-acid battery. It must be recycled or disposed of in  
an environmentally sound manner. Do not dispose of a lead-acid battery in  
your regular household trash. The incineration, landfilling or mixing of sealed  
lead-acid batteries with household trash is prohibited by law in most areas.  
• Return exhausted batteries to a federal or state approved lead-acid battery  
recycler, such as a local seller of automotive batteries. Contact your local waste  
management officials for other information regarding the environmentally sound  
collection, recycling and disposal of lead-acid batteries. If you live in the State  
of Florida or Minnesota, it is prohibited by law for anyone to throw lead-acid  
batteries in the municipal waste stream.  
2
 
Warranty  
ORECK MANUFACTURING COMPANY: (ORECK gives you the following limited warranty  
for this product only if it was originally purchased for use, not resale, from ORECK or an  
ORECK Authorized Retail Dealer.)  
ORECK will repair or replace, free of charge, to the original purchaser, any part which is  
found to be defective in material or workmanship within one (1) year of the date of purchase.  
This limited warranty applies to normal domestic use. Any commercial use of this product will  
void this limited warranty.  
This limited warranty does not cover the replacement of expendable or consumable parts  
such as belts, brushes, bulbs, batteries and other parts subject to normal wear.  
This limited warranty does not apply to any part subjected to accident, abuse, commercial  
use, alteration, misuse, damage caused by fire or act of God, the use of voltages other than  
indicated on the serial number plate of this product or service of this product by other than  
ORECK or an ORECK Factory Authorized Service Center.  
ORECK does not authorize any person or representative to assume or grant any other war-  
ranty obligation with the sale of this product.  
ORECK’s limited warranty is valid only if you retain proof of purchase from ORECK or an  
ORECK Authorized Retail Dealer for this product. If you purchase this product from any other  
source, your purchase is “AS IS,” which means ORECK grants you no warranty, and that you,  
not ORECK, assume the entire risk of the quality and performance of this product, including  
the entire cost of any necessary servicing or repairs of any defects.  
ORECK’s liability for damages to you for any costs whatsoever arising out of this statement  
of limited warranty shall be limited to the amount paid for this product at the time of original  
purchase, and ORECK shall not be liable for any direct, indirect, consequential or incidental  
damages arising out of the use or inability to use this product.  
Some states do not allow the exclusion or limitation of incidental or consequential damages,  
so the above limitation or exclusion may not apply to you.  
ALL EXPRESS AND IMPLIED WARRANTIES FOR THIS PRODUCT, INCLUDING IMPLIED WAR-  
RANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMIT-  
ED IN DURATION TO THE WARRANTY PERIOD, AND NO WARRANTIES, WHETHER  
EXPRESS OR IMPLIED, WILL APPLY AFTER THIS PERIOD.  
Some states do not allow limitations on the duration of implied warranties, so the above lim-  
itation may not apply to you.  
This warranty gives you specific legal rights, and you may also have other rights which vary  
from state to state.  
3
 
Assembly  
1. ON/OFF handle switch  
MODEL AV-701B  
2. Adjustable handle control lever  
3. Release button for hand held unit  
4. Charging socket A  
5. Hand held unit on/off switch  
6. Battery (built-in the hand held unit)  
7. Charging lamp  
8. Release button for dirt cup  
9. Dust filter (included in the hand held unit)  
10. Reset button  
11. Brush lamp  
12. Power brush  
13. Crevice tool (built-in)  
14. Upholstery brush  
15. Adapter (power supply/charger)  
16. Charging socket B  
PART # 40179-01  
PART # 40180-01  
PART # 40181-01  
4
 
Operating Instructions  
Charging the Unit  
1. Before charging, make sure both switches  
are in the “off” position. Then insert the  
adapter into an electrical outlet and the  
plug into charging socket A or B. Charge  
batteries for 10 - 12 hours before initial  
use. Normal charging time is 8 - 10  
hours. After that time, the cleaner will  
run for approximately 15 - 20 minutes.  
Caution: Do not allow the battery  
to run down completely before  
charging. In doing so, serious  
problems may occur in the battery  
life cycle.  
2. A red lamp indicates the unit is charging.  
A green lamp indicates the unit is fully  
charged. If you have a charging problem,  
refer to the chart in the  
“Troubleshooting” section.  
3. It is normal for the adapter to feel warm  
while the battery is charging.  
4. The cleaner can be on a constant charge  
so it is always ready for use (it is over-  
charge protected). However, if the cleaner  
will not be used for several weeks at a  
time, unplugging it is recommended.  
ON/OFF handle switch  
1
Fig. 1  
One-touch sliding “On/Off” switch for  
convenient use.  
5
 
Release Button  
2
Fig. 2 To remove the hand held unit, push the release button. When finished  
cleaning, align the hand held unit against the wall bracket of the stick  
broom and snap it into place.  
Hand Held Unit ON/OFF Switch & Charging Indication Lamp  
3
Fig. 3 A red lamp indicates the unit is charging. A green lamp indicates the unit  
is fully charged.  
Adjustable Handle Control Lever  
4
Fig. 4 The handle can be set to desired working position. Loosen the handle by  
turning the control lever to the center position, then pull the handle to the  
desired length and secure it by turning it to the locked position.  
6
 
Cleaning the Dust Filter  
5
6
7
Fig. 5 Press the release button and remove the dirt cup from cleaner.  
Fig. 6 Empty the dirt cup.  
Fig. 7 It is also recommended to empty and clean the filter after each  
use. To remove debris from the filter, tap it on a hard surface or brush it  
with a soft brush. The filter can be washed in warm soapy water using a  
soft brush if necessary. Dry it completely before replacing it into the dirt  
cup.  
Power Brush  
8
Important: Disconnect cleaner from electrical outlet.  
Fig. 8 To maintain cleaning effectiveness, regularly remove hair, lint, strings,  
threads, etc. from the brush roll with a knife or scissors. If a blockage  
resulting from hair, lint, strings, etc. is caught in the brush roll, the  
cleaner will stop automatically for safety purposes. After removing the  
blockage, push the “reset button” on the brush assembly. A green light  
will appear in the brush lamp next to the reset button and the cleaner  
should run normally.  
7
 
Removing and Replacing the Battery  
(See Important Battery Handling Instructions on page 2)  
Note: Do not remove the battery to charge it. The battery should only be  
removed if you plan to replace it or you are disposing of the cleaner.  
Examine the battery, charger and their connectors for excessive wear or  
damage each time you change the battery. If damage or excessive wear is  
detected, do not use the charger or the battery until you have replaced the  
worn or damaged party.  
9
10  
11  
12  
Fig. 9 Slide the battery cover off the bottom of the hand held unit.  
Fig. 10 Remove the battery from the motor housing.  
Fig. 11 Press tab on connector “A” to release battery from motor housing. Plug  
new battery into connector “A”. (Be careful to connect plus and minus  
pole correctly.)  
Fig. 12 When inserting the battery into the motor housing, the wires must go in  
first and they must be placed in front of the battery. Replace battery  
cover.  
Battery Disposal  
Your cleaner is equipped with a replaceable sealed lead-acid battery  
(Type No. LC-R064R2P). When the battery no longer charges, it must be  
removed from the cleaner and disposed of in an environmentally safe manner.  
Do not dispose of a lead-acid battery in your regular household trash.  
The incineration or mixing of sealed lead-acid batteries with household trash  
is prohibited by law in most areas. Return exhausted batteries to a federal or  
state approved lead-acid battery battery recycler. Contact your local waste  
management officials for other information regarding the environmentally  
sound collection, recycling and disposal of lead-acid batteries. If you live in the  
State of Florida or Minnesota, it is prohibited by law for anyone to throw away  
lead-acid batteries in the municipal waste stream.  
8
 
Troubleshooting Guide  
PROBLEM  
AREAS TO CHECK  
What happens if the red charging indicator Make sure the adapter plug and socket  
is not lit while charging?  
are plugged in properly.  
Both the hand held unit and the stick  
broom need to be turned off while charging.  
The green light is on and the unit is fully  
charged, but the unit is inoperative.  
Remove adapter from charging socket.  
Charge battery again.  
New battery may be required, contact  
an Authorized Service Center.  
Suction power is not sufficient.  
Empty dirt cup and clean dust filter.  
Charge battery again.  
New battery may be required, contact  
an Authorized Service Center.  
Running time is not sufficient.  
Charge battery again.  
New battery may be required, contact  
an Authorized Service Center.  
Machine does not stop when switched off.  
Separate hand held unit from the  
stick broom.  
Both switches on the hand held unit and  
the stick broom must be in the off  
position.  
Brush does not work while operating.  
Clean the power brush.  
Push the reset button and turn it on  
again.  
Contact an Authorized Service Center.  
Hand held unit works, but the stick broom  
does not.  
Take the hand held unit off and locate the  
four (4) silver prongs on the bottom of the  
unit. If the prongs are not clean, wipe  
them with a dry cloth.  
Contact an Authorized Service Center.  
©2003 Oreck Holdings, LLC. All rights reserved. All word marks, logos, product configurations, and registered trademarks are  
owned and used under the authority of Oreck Holdings, LLC. Printed in America  
40178-01 REV A  
2/03 ECN# R-6933  
 

Minolta Digital Camera XG M User Manual
Minolta Webcam Zoom 70 User Manual
MTD Log Splitter 753 05193 User Manual
National Instruments DJ Equipment NI LabVIEW User Manual
Netopia Network Router 3347W User Manual
Nextar DVD Player MP907 User Manual
Omega Engineering Satellite Radio LDX 2 User Manual
Oreck Home Security System S063 User Manual
Palsonic Flat Panel Television TFTV380 User Manual
Panasonic Network Card 2SD0592A User Manual